BDFHYK 5x112 Wheel Spacers 12mm 15mm for Audi A3 A4 A5 A6 A7 TT Volkswagen CC Beetle Phaeton Mercedes C230 W210 W212, 66.56mm Hub Bore, Set of 2

5x112 Wheel Spacers in 12 mm and 15 mm for Compatible European Vehicles

These BDFHYK 5x112 wheel spacers are available in 12 mm and 15 mm thickness options with a 66.56 mm center bore. They are intended for compatible Audi, Volkswagen, and Mercedes wheel setups where the vehicle hub, wheel center opening, bolt pattern, hardware, and available clearance match the listed specifications.

The spacers move the wheels outward to address a tucked appearance, create additional inner space near brakes or suspension, or adjust the position of selected aftermarket wheels. They do not change the bolt pattern. Because many Audi and Volkswagen applications use different center-bore dimensions, do not select this product from the vehicle name alone. Confirm the 66.56 mm interface on the exact vehicle and wheel setup.

Common Fitment Scenarios

• Mild stance adjustment: Moves compatible wheels outward without changing the wheel bolt pattern.
• Inner brake or suspension clearance: May create room when the inner wheel or tire sits close to brake calipers, struts, or suspension components.
• Aftermarket wheel positioning: Can help compensate when wheel width or positive offset places the wheel too far inward.
• One-axle setup: The set of two supports equal spacing on the left and right side of one axle.

Choosing 12 mm or 15 mm

The 12 mm option is suitable when a smaller outward adjustment is enough to address wheel tuck or minor inner clearance. The 15 mm option moves the wheel 3 mm farther outward and may be chosen when more clearance or a more visible position change is required. The thicker option also places the tire closer to the fender. Measure both the inner interference and the remaining outer clearance before selecting a thickness.

Key Product Parameters

• Vehicle and wheel bolt pattern: 5x112
• Thickness options: 12 mm or 15 mm
• Center bore: 66.56 mm
• Product style: Slip-on wheel spacer
• Package quantity: Set of 2
• Hardware: Mounting bolts are not included; compatible extended hardware may be required
• Listed applications: Selected Audi, Volkswagen, and Mercedes vehicles using the exact listed dimensions

Hardware Requirements for Thin Slip-On Spacers

Adding 12 mm or 15 mm between the hub and wheel changes the required usable hardware length. Do not assume the original wheel bolts provide enough thread engagement. Confirm the correct additional bolt or stud length, thread pitch, lug-seat type, and wheel mounting-pad design for the exact vehicle and wheel. Hardware that is too short, too long, or uses the wrong seat can prevent correct installation.

Fitment Checks Before Ordering

• Confirm the vehicle and wheel both use 5x112.
• Verify the vehicle hub and selected wheel are compatible with the 66.56 mm center bore.
• Measure the amount of inner clearance needed before selecting 12 mm or 15 mm.
• Check tire-to-fender and tire-to-liner clearance after the outward change.
• Confirm compatible extended mounting hardware, thread engagement, and lug-seat type.
• Inspect brake-caliper clearance, hub-lip length, wheel mounting-pad shape, and full wheel seating.

Installation and Maintenance

Install the spacers only on clean, flat, undamaged mounting surfaces. Confirm the spacer sits fully against the hub and the wheel sits fully against the spacer. Use a calibrated torque wrench and the applicable tightening procedure. Do not stack spacers. Recheck torque after initial driving and inspect the assembly whenever the wheels are removed.