5x114.3 Hubcentric Wheel Spacers 15mm for Nissan 350Z 370Z Infiniti G35 G37 FX35 Altima, M12x1.25 Studs, 66.1mm Hub Bore, Set of 2

15 mm 5x114.3 Hubcentric Wheel Spacers for Nissan and Infiniti

These BDFHYK 5x114.3 wheel spacers are designed for compatible Nissan 350Z, 370Z, Altima and selected Infiniti G35, G37, FX35, and other listed applications using a 66.1 mm hub bore and M12x1.25 wheel hardware. The 15 mm thickness provides a moderate outward wheel-position change.

The two-piece package is intended for one axle. It can be used where measurements show that the front or rear wheels sit too far inward or need additional inner clearance. Do not assume the front and rear axles need the same spacing.

When These Wheel Spacers May Help

• Move compatible wheels outward when the current setup sits too far inward.
• May create additional inner clearance near brake, suspension, or tire components.
• Support selected aftermarket wheels when offset and center-bore measurements are compatible.
• Create a wider wheel position without changing the wheel itself.

Key Fitment Specifications

• Bolt pattern: 5x114.3 / 5x4.5
• Thickness: 15 mm / approximately 0.59 inch
• Center bore: 66.1 mm
• Thread pitch: M12x1.25
• Package quantity: Set of 2
• Listed applications: Compatible Nissan 350Z, 370Z, Altima and selected Infiniti G35, G37 and FX35 applications

Measure Before Ordering

Vehicle listings are a starting point, not a substitute for measuring the actual hub and wheel. Confirm the bolt pattern, vehicle-hub diameter, wheel center bore, thread pitch, wheel offset, wheel width, tire size, lug-seat style, brake package, and suspension configuration. Check original stud protrusion and the depth of the wheel pockets so the wheel can sit fully flat against the spacer. Also measure fender and liner clearance at ride height, full steering lock, and expected suspension compression.

Installation and Torque Checks

Clean rust, paint buildup, and debris from every mounting face. The spacer must sit flush against the hub, and the wheel must sit flush against the spacer. Tighten compatible hardware in a star pattern with a calibrated torque wrench and the applicable vehicle or hardware specification. Do not stack spacers or install them over damaged studs, lug nuts, or uneven mounting surfaces. Recheck torque after initial driving and during routine wheel service. Professional installation is recommended when fitment or clearance is uncertain.