BDFHYK 5x114.3 Wheel Spacers 1.5 Inch / 2 Inch for Ford Explorer Ranger Edge Lincoln Aviator Mercury Jeep Cherokee, 1/2-20 Studs, 82.5mm Hub Bore, Set of 4

1.5 Inch or 2 Inch 5x114.3 Wheel Spacers for Ford, Lincoln, Mercury, and Jeep

This BDFHYK listing offers 1.5 inch and 2 inch wheel spacer options for compatible Ford Explorer, Ranger, Edge, selected Lincoln Aviator, Mercury, Jeep Cherokee, and other listed 5x114.3 / 5x4.5 applications using 1/2-20 wheel hardware. Each selected variant includes four spacers with an 82.5 mm center bore.

Both thicknesses use a non-hubcentric design. The center bore provides hub clearance but does not positively center the spacer. Proper fitment therefore depends on correct dimensions, clean and flat mounting surfaces, compatible lug hardware, even seating, and gradual star-pattern tightening.

Choose the Thickness for Your Setup

• 1.5 inch / 38.1 mm: A substantial outward shift for measured inner-clearance needs or a noticeably tucked wheel position, with less outer movement than the 2 inch option.
• 2 inch / 50.8 mm: The larger option for setups that require more outward movement. It has the greatest effect on fender, liner, steering, and suspension-compression clearance.

Choose the smallest thickness that satisfies the measured clearance requirement. A thicker spacer can add more room on the inner side, but it also reduces available space on the outer side of the tire.

Scenario-Based Fitment Solutions

• Aftermarket wheels sit too far inward: Either thickness can change the effective wheel position when the wheel offset is otherwise compatible.
• Inner tire or wheel contact: The outward movement may help create room near control arms, suspension components, liners, or brake hardware.
• A wider stance is desired: The selected spacer moves the wheels outward without replacing the wheels, provided the body has enough clearance.
• Front and rear require the same correction: The four-piece package supports all four wheels only when both axles have been measured separately.

Key Product Parameters

• Bolt pattern: 5x114.3 / 5x4.5
• Thickness options: 1.5 inch / 38.1 mm or 2 inch / 50.8 mm
• Center bore: 82.5 mm
• Thread pitch: 1/2-20
• Centering design: Not hubcentric
• Package quantity: Set of 4 in the selected thickness
• Listed applications: Compatible Ford Explorer, Ranger, Edge, selected Lincoln, Mercury, and Jeep Cherokee applications

Fitment and Pre-Installation Checks

Confirm the 5x114.3 bolt pattern, 1/2-20 hardware, center-bore clearance, wheel center bore, offset, width, tire size, lug-seat style, brake package, and suspension configuration. Measure original stud protrusion and wheel-pocket depth so the wheel can sit fully flat. Check the fender, flare, liner, brake, and suspension clearances at ride height, full steering lock, and expected compression. Lifted, lowered, leveled, and aligned vehicles require the same checks.

Installation and Maintenance

Remove rust, paint buildup, dirt, and debris from the hub, spacer, and wheel mounting faces. Hand-start all compatible hardware, tighten gradually in a star pattern, and finish with a calibrated torque wrench using the applicable specification. Do not stack spacers or install over damaged studs or lug nuts. Recheck torque after initial driving and inspect the assembly during regular tire service.