5x114.3 Hubcentric Wheel Spacers 15mm for Tesla Model 3 2017-2024 Model Y 2020-2024, M14x1.5 Studs, 64.1mm Hub Bore, Set of 2

15 mm 5x114.3 Hubcentric Wheel Spacers for Tesla Model 3 and Model Y

These BDFHYK wheel spacers are designed for compatible 2017-2024 Tesla Model 3 and 2020-2024 Tesla Model Y applications using a 5x114.3 bolt pattern, 64.1 mm hub bore, and M14x1.5 wheel hardware. The 15 mm thickness offers a moderate outward wheel-position change.

The two-piece package covers one axle. Choose 15 mm when measurements show that a moderate shift is enough to reduce a tucked wheel position or create the needed inner clearance. Check wheel offset, tire size, brake package, ride height, and alignment before ordering.

When These Wheel Spacers May Help

• Move compatible wheels outward when the current setup sits too far inward.
• May create additional inner clearance near brake, suspension, or tire components.
• Support selected aftermarket wheels when offset and center-bore measurements are compatible.
• Create a wider wheel position without changing the wheel itself.

Key Fitment Specifications

• Bolt pattern: 5x114.3 / 5x4.5
• Thickness: 15 mm / approximately 0.59 inch
• Center bore: 64.1 mm
• Thread pitch: M14x1.5
• Package quantity: Set of 2
• Listed applications: Compatible Tesla Model 3 2017-2024 and Tesla Model Y 2020-2024 applications

Measure Before Ordering

Vehicle listings are a starting point, not a substitute for measuring the actual hub and wheel. Confirm the bolt pattern, vehicle-hub diameter, wheel center bore, thread pitch, wheel offset, wheel width, tire size, lug-seat style, brake package, and suspension configuration. Check original stud protrusion and the depth of the wheel pockets so the wheel can sit fully flat against the spacer. Also measure fender and liner clearance at ride height, full steering lock, and expected suspension compression.

Installation and Torque Checks

Clean rust, paint buildup, and debris from every mounting face. The spacer must sit flush against the hub, and the wheel must sit flush against the spacer. Tighten compatible hardware in a star pattern with a calibrated torque wrench and the applicable vehicle or hardware specification. Do not stack spacers or install them over damaged studs, lug nuts, or uneven mounting surfaces. Recheck torque after initial driving and during routine wheel service. Professional installation is recommended when fitment or clearance is uncertain.