Front Left & Right CV Axle Shaft Assembly Set for Honda Odyssey 2005-2006 | Replace NCV36564 NCV36577

Honda Odyssey CV Axle Shaft Assembly Set for 2005-2006

This BDFHYK front left and right CV axle shaft assembly set is an OE-style aftermarket replacement for the listed Honda Odyssey applications. It is intended for a vehicle being inspected for CV axle clicking, vibration under acceleration, grease around a damaged boot, or looseness at the front driveline. Because a front CV axle can vary by engine, transmission, drivetrain, build configuration, and axle side, confirm the vehicle details and interchange numbers before ordering.

Honda Odyssey CV Axle Fitment

The fitment range above is based on the current product application data. Before installation, compare the original front axle assembly with the replacement, including overall configuration, spline ends, mounting interfaces, boot layout, and the left/right position. Do not rely on model year alone when the same vehicle was offered with more than one powertrain or transmission configuration.

OE and Interchange Numbers for This Honda Odyssey CV Axle

Use the following references as cross-check numbers rather than as stand-alone proof of fitment: 44304SHJA01, 44306SHJA01, 44305SHJA01, 44305SHJC01, 44305SJCA01, 44305SJCA11, NCV36564, NCV36577, 664224, 66-4224, 664225, 66-4225. Match at least one known number from the removed axle, an OE catalog, or a qualified parts lookup, then confirm the front left and right position and vehicle configuration.

When to Inspect or Replace the Honda Odyssey Front CV Axle

A worn CV joint or damaged axle boot can produce symptoms that change with steering angle, load, and road speed. These signs do not prove that the CV axle is the only failed component, but they are common reasons to inspect the front driveline:

• Clicking or popping while turning, especially under light acceleration.
• Shudder, vibration, or a cyclic sensation that becomes more noticeable while accelerating.
• Grease thrown onto the wheel, suspension, splash shield, or nearby components from a split boot.
• Clunking when shifting between acceleration and deceleration.
• Visible boot cracking, loose clamps, joint play, or shaft damage found during service.

Wheel bearings, tires, engine or transmission mounts, suspension joints, and brake components can create similar noise or vibration. Diagnose the cause before replacing the CV axle shaft assembly.

What This Honda Odyssey Front Axle Replacement Includes

This listing supplies a two-piece front axle set: 1 front left CV axle shaft assembly and 1 front right CV axle shaft assembly. The assembly is listed with protective CV joint boots, grease, and retaining clamps. It is an OE-style aftermarket replacement intended to match the listed position and interchange references when all fitment checks agree.

Fitment Checks Before Ordering

• Confirm the exact year, make, model, trim, engine, transmission, and drivetrain.
• Confirm that the required position is front left and right.
• Compare the original axle configuration and all available OE or interchange numbers.
• Check spline engagement, shaft configuration, seal surface, retaining method, and hub connection.
• Verify whether the service procedure requires a new axle nut, seal, clip, or other one-time-use hardware; these items are not listed as included unless shown in the package.

Installation Checkpoints for Honda Odyssey Front Axle Replacement

Support the vehicle correctly and follow the vehicle-specific service procedure. Inspect the wheel hub, transmission or intermediate-shaft seal area, suspension joints, and axle mating surfaces while the original axle is removed. Do not pull or hammer on the replacement boots. Make sure the inner connection is fully seated, the outer splines engage without force, and all fasteners are tightened to the applicable specification. After the CV axle replacement, check for leaks, abnormal noise, boot contact, and vibration during a controlled road test.

Package Includes

• 1 front left axle shaft assembly and 1 front right axle shaft assembly.